Alcatel Omni Switch/Router User Manual page 1055

Configuring the Diagnostic Test Environment
Configuring Tests for Ethernet Modules
Tailoring of applicable Ethernet modules includes selection of Port Speeds and of Port Modes.
To configure applicable diagnostic tests for an Ethernet 10/100 switching module in slot 3,
enter:
The following is a sample display of the test configuration for an Ethernet 10/100 switching
module.
To change any of the values above, enter the line number, followed by an equal sign, and
followed by the new value. For example, to change the field to half duplex, enter
The configurable fields displayed by the command for an Ethernet module are
described below.
. Allows the user to select to bypass this slot when the command
is issued. The default is .
. Allows the user to select module port speed during the diagnostic port test. Selec-
tion includes , , or . The default is , which alternates
10/100BaseT 100BaseT 10BaseT
the speed of the port test from 10 to 100 on each pass of the port test.
. Allows the user to select module port mode during diagnostic port test. Selection
includes Full Duplex or Half Duplex. The default value is .
Enter if you want to make this change. If you want to cancel this change, enter
and the command will terminate.
Page 36-17