Modifying An Autotracker Vlan - Alcatel Omni Switch/Router User Manual

Modifying an AutoTracker VLAN

Modifying an AutoTracker VLAN
After you set up a
Status of each of the rules. You use the
You must specify the Group and
example, to modify the
After entering a valid
The first half of the display shows the current configuration of this
sample shows a
a Protocol Rule has been set up, but this rule has not been enabled.
The second half of the displays a list of the
basic information such as the Admin Status and Description. You can also add rules, delete
rules, and enable or disable the rule. To modify an attribute, enter the number next to the
option you want to modify and press
The following sections describe each of the six Available Options for the
Changing a VLAN's Admin Status
1. At the
2. The following prompt displays:
Type an
direct data flow. A disabled
The system returns to the
, or quit modifying the
VLAN
Page 22-24
you can modify its Admin Status, description, rules, and the Admin
VLAN
VLAN
3 in Group 4, you would specify:
VLAN
command a screen similar to the sample below displays:
3 in Group 4 with a description, "
VLAN
prompt enter a and press
to enable the or a
VLAN
is saved, but cannot become active.
VLAN
by typing a .
VLAN
command to modify a
numbers and they must be separated by a colon. For
AT VLAN 3
attributes you can modify. You can modify
VLAN
.
.
to disable it. An enabled
menu. You can modify more attributes for this
as follows:
VLAN
. For example, this
VLAN
." The is Enabled and
VLAN
command.
starts using policies to
VLAN