Sample Test Session: Ethernet Module - Alcatel Omni Switch/Router User Manual

Running Hardware Diagnostics

Sample Test Session: Ethernet Module

Test sessions and results will vary among the various switching modules. This section shows
the output from a test session on an
requested to be run one time. The command to start this test is:
After you enter the
Enter to run port tests or
instructed on how to cable the ports. This cabling will vary depending on the test
configuration, module type, number of ports and cable type. In this example, the
following displays:
Cable the ports according to the instructions. For Ethernet tests, you should use cross-over
cable to connect the ports. Press
Page 36-12
. The module is in slot 3 and all tests were
ESX-C-12
command line, the following displays:
to skip them. If you select to run the port tests, you will be
when you have finished the cabling.