Combining Search And Filter Commands - Alcatel Omni Switch/Router User Manual

UI Table Filtering (Using Search and Filter Commands)
2. Type at the
prompt, enter the desired text pattern (remember to type the text pattern exactly as it
would appear in the
Press
Note that only those lines containing Lane services are now displayed on the screen. All
other table entries have been filtered from the

Combining Search and Filter Commands

If you receive a
exceeds the maximum number of table entries designated by the
refine your results, you can combine the Search and Filter commands.
To combine the Search and Filter commands, type at the Filter mode's
followed by a revised text pattern of up to 80 characters. Note that you can combine the
Search and Filter commands only after you have executed a Filter command and received a
prompt at the bottom of the resulting page.
Real World Example
The following example combines the Search and Filter commands to find specific IP address
information in the
enabled and the default is set at 22 lines. For more information, refer to page 4-38.)
Page 4-42
prompt. The Filter prompt ( ) will appear automatically. At the Filter
table):
UI
. A screen similar to the following will be displayed:
prompt after using the Filter command, the filtered information still
o Reminder o
Both the Search and Filter commands are case sensi-
tive. When using these commands, be sure to type the
text pattern exactly as it would appear in the text
table.
table. (Before using this example, be sure that the
.
UI
command. To further
UI
prompt,
mode is