Wsx-Fe1-Sc Cabling/Jumper Settings - Alcatel Omni Switch/Router User Manual

WAN Modules

WSX-FE1-SC Cabling/Jumper Settings

The supports both twisted pair (120 Ohm) and coaxial (75 Ohm) cable types. The
WSX-FE1-SC
default is 120 Ohm. You must set a pair of jumpers ( and ) on the back of the board to
JP2 JP4
correspond to the type of cable you are using. For more detailed information on the types of
cables to use with this module, see Appendix B, "Custom Cables." The illustration below
shows the correct jumper positions.
o Note o
is reserved. Do not set a jumper across .
JP3 JP3
Cable Termination Jumpers for WSX-FE1-SC
Page 3-35