Wsx Self-Configuration And Virtual Circuits - Alcatel Omni Switch/Router User Manual

WSX Self-Configuration and Virtual Circuits
The following diagram summarizes the self-configuration features of the
assumes no configuration parameters are entered for the
Group 1, and no Routing or Trunking are configured.
–
Cable plugs into
WSX
—
Board senses cable type
and adjusts circuitry.
™
The Frame Relay network returns a
message that includes
STATUS
for all VCs on this physical port and
whether the VCs are active, inac-
tive, or deleted.
STATUS
After mapping virtual circuits to virtual ports, the
are repeated periodically by the
RIES
configured through software. See Setting Configuration Parameters on page 29-22 for infor-
mation on setting these parameters.
serial port.
DLCIs
WSX Initial Port and Virtual Circuit Configuration
. The intervals between
WSX

WSX Self-Configuration and Virtual Circuits

WSX
. Default bridging is set up on
WSX
˜
The sends
WSX STATUS ENQUIRY
message to Frame Relay network.
This message requests the DLCIs of
all virtual circuits and the active/
inactive status of the those VCs.
STATUS ENQUIRY
š
maps each (virtual circuit)
WSX DLCI
to a virtual port within the switch. In
addition, all of these virtual ports are
assigned to default .
VLAN 1
Virtual Port Virtual Circuit
8
9
10
is ready to send data.
WSX
STATUS ENQUIRES
. This example
16
17
18
STATUS ENQUI-
can be
Page 29-7