Running Hardware Diagnostics - Alcatel Omni Switch/Router User Manual

Running Hardware Diagnostics

Running Hardware Diagnostics
The command initiates one or more test routines on a switching module that you
specify. You can also optionally test all switching modules in one test session. Test status,
instructions, and a summary of results are provided as output. Start a diagnostic test session
using the following command syntax:
where
Descriptions of each test follows:
Page 36-6
Indicates the slot number in the Omni Switch/Router for the module on
which you want to run tests. If you enter
switching modules in the chassis will be tested. This parameter is required;
if you do not enter a slot number then the test session will not start.
Indicates the number of times to run the specified tests on the module.
This value can be an integer between 0 and 999. A value of zero (0)
repeats the test infinitely. The default value is 1. This default will be
assumed if you do not enter a
Indicates the test to be performed on the module. You can indicate the test
name or to run all tests. You can enter only one test name or
default is . This default will be assumed if you do not enter a
o Note o
A combination of
set to allows the user to run either the port test
infinitely or all off-board tests infinitely. If the user
chooses to run the port test when prompted, all the
static tests (memory and control/status register tests)
are run once, followed by an infinite run of the port
test. See Sample Command Lines on page 36-9 for
more information.
Tests the Alpine registers. Test the Alpine control logic, registers, and
data/address lines.
Tests the command/status registers. Includes testing management bus
buffers, management bus read/write control logic, reset and
, and reset circuitry.
ID EEPROM
Tests the Giga-Chip registers. Test the Giga-Chip control logic, registers,
and data/address lines.
Tests the 's local memory. Includes testing the
HRE-X
functions, data/address, and the memory.
Tests the 's functions. Packets are generated by the
HRE-X
to the port, and claimed by the
routing information to the claimed packet and place it back on
be claimed and verified by the
Running Diagnostics on an Entire Chassis on page 36-20.
Performs a port test using the internal loopback at the
interface. Packets are generated by the
returned through an internal loopback within the
verifies the packets on a bit by bit basis.
for this parameter, then all
.
set to and
HRE-X
. The will insert additional
HRE-X HRE-X
. This test can be bypassed. See
MPX
PHY
and sent out to the port and
MPX
or framer. The
PHY
. The
.
memory,
LED
read/write
, sent out
MPX
to
MVBUS
or framer
MPX