Alcatel Omni Switch/Router User Manual page 621

Defining a Port Policy
After you enter the Administrative Status, the following menu displays:
1. Press . If this is a VLAN in a non-mobile Group refer to Chapter 19 for a detailed
explanation of the two ways port policies may be configured.
As of the current release, the MAC Address Range Rule
and DHCP MAC Range are not supported.
2. The following prompt displays:
Indicate whether or not you want to enable the Administrative Status for this rule. Type
to enable or to disable. If you enable the rule, the switch will use it to determine
membership of devices. If you disable the rule, then the switch will not use this rule, but
the parameters you set up will be saved. The Admin Status for a Policy is different from
the Admin Status for the
. You can enable or disable the rule at a later time using the
VLAN
3. The following prompt displays:
Enter the physical ports that you want included in this
ports at a time. Use the <slot>/<port> format. For example, to include port 7 from the
module in slot 2, you would enter
sary for specifying physical
ports used over
ATM
4. The following prompt displays:
You can set up multiple rules for the same
more rules in addition to the port rule specified here. If you enter , you will be
prompted for the next rule that you want to set up on this
the appropriate section to configure that rule.
If you enter , you will receive a message, similar to the one below, indicating that the
was set up.
VLAN
You are done setting up rules.
o Note o
as it controls only to this specific rule within this specific
VLAN
. (The service and instance numbers are not neces-
ports. They are only necessary when specifying logical
LAN
, , and Frame Relay.)
FDDI
VLAN
Defining and Configuring AutoTracker Policies
. You may enter multiple
VLAN
. Enter a here if you want to set up
. Follow the directions in
VLAN
command.
Page 20-5