Alcatel Omni Switch/Router User Manual page 627

Defining a Network Address Policy
After you enter the Administrative Status for this mobile group or AutoTracker
following menu displays:
1. Press and press
2. The following prompt displays:
Indicate whether or not you want to enable the Administrative Status for this rule. Type
to enable or to disable. If you enable the rule, the switch will use it to determine
membership of devices. If you disable the rule, then the switch will not use this rule, but
the parameters you set up will be saved. The Admin Status for a Policy is different from
the Admin Status for the mobile group or AutoTracker
specific rule. You can enable or disable the rule at a later time using the
command.
3. The following prompt displays:
Enter the protocol for which you want to define this network address rule. Enter a
and a for IPX. The prompts that follow are different for IP and IPX. These differences
are due to the different conventions used by the protocols for network address formats.
Follow the procedure below the network protocol you are setting up.
Set Up an IP Address
a. To specify an IP address, enter a
b. The following prompt displays:
Enter the IP address that you want to include in this mobile group or AutoTracker
. Enter the address in dotted decimal notation or hexadecimal notation (e.g.,
VLAN
198.206.181.10).
c. The following prompt displays:
Enter the IP Subnet mask for this address. The default subnet mask is shown in paren-
theses and is automatically derived from the IP address class entered in Step b.
d. Go on to Step 4 below.
.
at the
Defining and Configuring AutoTracker Policies
as it controls only to this
VLAN
prompt.
, the
VLAN
for IP
Page 20-11