Alcatel Omni Switch/Router User Manual page 635

Protocol Specified by Ether-Type
a. To specify a protocol by Ethernet type, enter at the
ing prompt displays:
b. Enter the desired Ethernet type in hex. You must enter two bytes of data. For exam-
ple, enter 0800 to specify
specified Ethernet type will be members of the mobile group or AutoTracker
c. Go on to Step 8 below.
Protocol Specified by DSAP and SSAP
a. To specify a protocol by
menu. The following prompt displays:
b. Enter the destination service access protocol (
The following prompt displays:
c. Enter the source service access protocol (
of one byte of data. All devices that use the specified source and destination
will be members of the mobile group or AutoTracker
d. Go on to Step 8 below.
Protocol Specified by SNAP
a. To specify a protocol by
menu. The following prompt displays:
b. Enter the desired
enter
0000008137
. All devices that use the specified
SNAP
group or AutoTracker
c. Go on to Step 8 below.
8. The following prompt displays:
You can set up more devices for this binding policy group. Enter a
set up more devices. If you enter , you will be prompted for the next rule that you want
to set up. Follow the directions in the appropriate section to configure that rule.
If you enter , you will receive a message, similar to the one below, indicating that the
was set up.
VLAN
You are done setting up rules for this mobile group or AutoTracker
or enter 0806 to specify
IP
(service access protocol) header, enter at the
SAP
(sub-network access protocol) type, enter at the
SNAP
value in hex. You must enter five bytes of data. For example,
SNAP
to specify or enter
IPX SNAP
SNAP
.
VLAN
Defining and Configuring AutoTracker Policies
. All devices that use the
ARP
) value in hex and press
DSAP
) value in hex. Each entry must consist
SSAP
.
VLAN
to specify AppleTalk
00000080F3
type will be members of the mobile
VLAN
menu. The follow-
.
VLAN
.
types
SAP
ARP
here if you want to
.
Page 20-19