Chassis Error Messages; Chassis Error Messages Table - Alcatel Omni Switch/Router User Manual

Chassis Error Messages

The slots in the messages within the following table are all zero based. That is, Slot 1 will be
displayed as "Slot 0," Slot 2 will be displayed as "Slot 1," etc.
Message
xxx xx
xxx
xxx
xxx
xxx
xxx

Chassis Error Messages Table

Corrective Action
Reboot the system, then use the Boot Line configuration to
force SLIP down at the boot line (refer to Appendix A "The
Boot Line Prompt").
Remove the module from the slot.
The module appears dead. Remove the module from the slot
and replace with a known good module.
xxx
The software has discovered a dead task. The system will
reboot automatically.
The system encountered an unexpected condition. Reboot the
switch.
The system is confused. Clear the system by rebooting it.
This may indicate a bad MPX. Try power cycling.
This may indicate a bad MPX. Try power cycling.
This may indicate a bad module in slot xxx. Try power cycling.
Reboot the system.
Try power cycling. If the problem remains, remove the module
and try another slot.
xxx Try power cycling. If the problem remains, remove the module
xxx
and try another slot.
Reset the clock by using the
Change stop bits by configuring boot line (refer to Appendix A
"The Boot Line Prompt").
This message appears only once if the configuration file is
removed.
command.
continued on next page...
Page 35-13
Error Messages