Display Detailed Information For One Or More Peers - Alcatel Omni Switch/Router User Manual

NTP Information Menu

Display Detailed Information for One or More Peers

The
associations of this switch. To view detailed
the
where
example, to show information for a peer with
A screen similar to the following is displayed:
It is possible to display information from more than one remote association by adding more
addresses when entering the
peer with IP address 1.1.1.4 and a peer with IP address 1.1.1.5, enter:
Field Descriptions
The following section describes the fields displayed using the
. The IP address of the remote association.
. The local interface address assigned by
, then the local address has yet to be determined.
. The host mode of this remote association. There are five possible modes: symmetric
active, symmetric passive, client, server, and broadcast. The displayed mode is assumed if this
association becomes the switch's host
List of Peers the Server Knows About on page 12-15. For a description of how to set a switch
host server, see Specify the Host Whose NTP Server We Talk To on page 12-34.
NTP
. The peer mode of this remote association. There are five possible modes: symmetric
active, symmetric passive, client, server, and broadcast. The displayed mode is assumed if this
association becomes the switch's host
List of Peers the Server Knows About on page 12-15. For a description of how to configure a
peer, see Configuring a New Peer Association on page 12-12
. The stratum level of the remote peer. If this number is
been synchronized.
Page 12-18
command allows you to view detailed
command in the following manner:
is the either the domain name or
NTP
NTP
information about any remote
NTP
information about a remote association enter
NTP
address of the remote association. For
IP
address 1.1.1.4, enter:
IP
command. For example, to display information on a
to the remote association. If this address is
NTP
server. For a description of the modes, see Display
server. For a description of the modes, see Display
, the remote peer has not
command.