Configuring System Information - Alcatel Omni Switch/Router User Manual

Configuring System Information
You can enter or modify a description of a switch, its location, and a contact person.
Although this information is not required, you may find it helpful in managing the switch. To
enter or modify the switch descriptions, perform the following steps.
1. At the system prompt, enter
The current system information will appear with a prompt asking if you want to change
any of the information; for example:
If you enter , the
If you enter , the current system information will be displayed line by line. To keep the
current value (shown in brackets) for a line, press
new value and press
Except for the
changes you make take place immediately.
If you entered , something similar to the following will be displayed.
2. Enter the new system contact or just press
to the following will be displayed.
3. Enter the new system name or just press
the following will be displayed.
4. Enter the new system location or just press
to the following will be displayed.
5. Enter the new system description or just press
lar to the following will be displayed.
The
if there is no traffic from those
CAM
the . You must reset the switch before this parameter takes effect. Duplicate
CAM
addresses will display as normal
and . See Duplicate MAC Address Support on page 9-30 for further discussion.
6. Enter a new duplicate
just press
command will exit and no changes will made (the default is ).
.
o Important Note o
indicates the time, in seconds, duplicate
. After this time, inactive
MACs
addresses in other software commands, such as
MAC
aging timer value (the valid range is from 10 to 1000000) or
MAC
to accept the default.

Configuring System Information

. To change a value, enter the
field, all
to accept the default. A screen similar
to accept the default. A screen similar to
to accept the default. A screen similar
to accept the default. A screen simi-
MACs
will age out of
MACs
remain in
MAC
Page 9-23