Alcatel Omni Switch/Router User Manual page 898

Setting Configuration Parameters
6) Error Threshold N392/nN2
The number of
Relay line is down and all associated virtual circuits are inactive. These errors may include
timeouts from
Relay network. By default, this threshold is set to 3, which is the standard Frame Relay default
value.
7) Monitored Events Counter N393/nN3
The number of status polling intervals over which the
should be greater than or equal to the
errors specified in
virtual circuits are considered inactive. By default, this counter is set to 4, which is the stan-
dard Frame Relay default value.
8) Default Bridging Group
The default Group for bridging any virtual circuits (user-configured or learned from the Frame
Relay network) that are not specifically assigned to a Bridging service. If you set this value to
0, then virtual circuits will not perform bridging unless assigned to a bridging service. By
default, the Default Bridging Group is set to 1. By entering a value here you can change the
default for this port.
9) Default Frame-Relay Bridging Mode
This field sets the default translation option for this port. When set to
performed on frames before they are sent out to the Frame Relay network; frames are sent as
is. When set to
format for this port before they are sent out to the Frame Relay network. Any
tions configured through the Switch menu are valid.
Page 29-26
protocol errors that will be tolerated before determining the Frame
DLCMI
polls and invalid
STATUS ENQUIRY
o Important Note o
This option should only be modified by experienced
Frame Relay network administrators.
within the number of polling intervals specified for the
, then the Frame Relay line is considered down and all associated
o Important Note o
This option should only be modified by experienced
Frame Relay network administrators.
o Important Note o
The
the Procedure Type has been set to
LMI
Relay ports.
, non-Ethernet frames are first translated to the default Ethernet frame
o Important Note o
The
user-side (i.e., the
LMI
) Frame Relay ports.
messages returned from the Frame
STATUS
. If the station received the number of
only applies to user-side (i.e.,
) Frame
only applies to
Procedure Type has been set to
is counted. This value
, no translation is
transla-
MAC