Viewing The Status Of An Ipx Default Route; Configuring An Ipx Default Route; Disabling An Ipx Default Route; Adding An Ipx Default Route - Alcatel Omni Switch/Router User Manual

Configuring an IPX Default Route

Configuring an IPX Default Route
A default IPX route may be configured for packets destined for networks unknown to the
switch. If RIP messages are disabled, packets can still be forwarded to a router that knows
where to send them. Use the
default route, or disable the default route.

Adding an IPX Default Route

To configure a default route, use the
example:
If the network ID indicates a direct network on the switch, the
specified, and the following prompt will display:
Enter the relevant address.

Viewing the Status of an IPX Default Route

To view the status of the default route, enter the
following displays:

Disabling an IPX Default Route

To disable the default route, enter the following:
If you enter the
Page 27-38
command to add a default route, view the status of a
command with the relevant network ID. For
command again, the following message displays:
address must also be
MAC
command. A message similar to the