Alcatel Omni Switch/Router User Manual page 1052

Running Hardware Diagnostics
The tests are complete at this point. A summary of the test results and failures is displayed at
the end of the test sequence. In this example, the module passed all tests except the port test.
The ESX-K-C-32 module in slot 3 should have a red to indicate diagnostics failure.
OK2 LED
And the section displays only the first three failures when you request
multiple test iterations.
You should now disconnect the cables used in the external loopback tests. Press and
the module will be restored to its normal, pre-testing state. The will remain red until
OK2 LED
the module is reset or the chassis is rebooted.
The main system command prompt re-displays.
Page 36-14