Alcatel Omni Switch/Router User Manual page 1070

Configuring a Switch with an MPX
8. You can enter an
different
IP
9. You can enter a log-in name for a remote host. A screen prompt similar to the following
displays.
10. You can enter a password for a remote host.
11. A screen prompt similar to the following displays.
Enter the command file name or press the
prompt similar to the following displays.
12. You can change the parameters for the console port. To change the value, enter the baud
rate (
length ( or ), stop bits ( , , or ), and port type ( for console,
down).
For example,
1 stop bit, and console mode.
A screen prompt similar to the following displays.
13. You can change the parameters for the modem port. To change the value, enter the baud
rate (
length ( or ), stop bits ( , , or ), and port type ( for modem,
down).
For example,
1 stop bit, and modem mode.
A screen prompt similar to the following displays.
Page A-8
address for the first hop router to a remote host (if the host is on a
IP
net). A screen prompt similar to the following displays.
, , or , or
sets the console port to 19,200 baud, no parity, 8-bit data length,
If the default baud rate shunt (
removed, any changes to the baud rate you enter will
be ignored and a message to that affect is displayed
during the boot process.
, , or , or
sets the modem port to 19,200 baud, no parity, 8-bit data length,
key to accept the default (
), the parity ( for none,
o Note o
) has not been
E1
), the parity ( for none,
). A
for even, or for odd), data
for , or for
SLIP
for even, or for odd), data
for , or for
SLIP