Ip Configuration - Enterasys VH-2402S Management Manual

IP Configuration

Use the IP Configuration screen to set the bootup option, or configure the
switch's IP parameters. The screen shown below is described in the
following table.
Use <TAB> or arrow keys to move, other keys to make changes.
Parameter
Interface Type
IP Address
Subnet Mask
Default Gateway
IP State
16 VH-2402S User Interface
Vertical Horizon Local Management -- VH-2402S
Network Configuration: IP Configuration
Interface Type
IP Address
Subnet Mask : 255.255.0.0
Gateway IP
IP State
Figure 2-8. IP Configuration
Default Description
Ethernet Indicates IP over Ethernet.
10.1.0.1 IP address of the stack you are managing when
accessing the agent module over the network.
The agent module supports SNMP over UDP/IP
transport protocol. In this environment, all
systems on the Internet, such as network
interconnection devices and any PC accessing
the agent module (or running management
software) must have an IP address.
Valid IP addresses consist of four numbers, of 0
to 255, and separated by periods. Anything
outside of this format will not be accepted by the
configuration program.
255.255.0.0 Subnet mask of the agent you have selected. This
mask identifies the host address bits used for
routing to specific subnets.
0.0.0.0 Gateway used to pass trap messages from the
switch's agent to the management station. Note
that the gateway must be defined if the
management station is located in a different IP
segment.
USER- Specifies whether IP functionality is enabled via
CONFIG manual configuration, or set by Boot Protocol
(BOOTP). Options include:
USER-CONFIG - IP functionality is enabled
: Ethernet
: 10.1.0.1
: 10.1.0.254
: USER-CONFIG
based on the default or user
specified IP Configuration.
(This is the default setting.)
VH-2402S