Transport Output Telnet; Session-Limit - NETGEAR GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch Cli Reference Manual

Command Line Interface Reference for the ProSafe 7300S Series Layer-3 Stackable Switches,

3.4.3 transport output telnet

This command regulates new outbound telnet connections. If enabled, new outbound
telnet sessions can be established until it reaches the maximum number of simultaneous
outbound telnet sessions allowed. If disabled, no new outbound telnet session can be
established. An established session remains active until the session is ended or an
abnormal network error ends it.
Default
Format
Mode
3.4.3.1 no transport output telnet
This command disables new outbound telnet connections. If disabled, no new outbound
telnet connection can be established.
Format
Mode

3.4.4 session-limit

This command specifies the maximum number of simultaneous outbound telnet sessions.
A value of 0 indicates that no outbound telnet session can be established.
Default
Format
Mode
3.4.4.1 no session-limit
This command sets the maximum number of simultaneous outbound telnet sessions to the
default value.
Format
Mode
3-10
enabled
transport output telnet
Line Config
no transport output telnet
Line Config
5
session-limit <0-5>
Line Config
no session-limit
Line Config
v4.1, October 2008
Administrative Access Commands