Figure 3-2. Model Sw518 Switches Used For Network Segmentation And As A Multiport Bridge To A High-Bandwidth Backbone - NETGEAR SW518 - Switch Installation Manual

4
Key:
1 = Model SW518 Ethernet switch (Normal/Uplink push button to configure port 18 set to Uplink position)
2 = Server with 20 Mbps connection (adapter card installed in server; duplex toggle switch for port 7 on
Model SW518 switch set to full-duplex mode)
3 = Model FS508 Fast Ethernet switch serving as network backbone (A Fast Ethernet hub can also be used.)
4 = Model EN516 Ethernet hubs (Normal/Uplink push button set to Uplink position)
5 = Server with 10 Mbps connection
6 = PCs with 10 Mbps connection
7 = PCs with 100 Mbps connection
Figure 3-2. Model SW518 switches used for network segmentation and as a
multiport bridge to a high-bandwidth backbone
Note: Full-duplex operation applies to point-to-point access only when attaching the
switch to a workstation, a server, or another switch. When connecting to a repeater or a
hub, set the port for half-duplex operation.
Applications
Installation Guide for the Model SW510 and Model SW518 Ethernet Switches
1
Link Full Link Full
4
2
3
Link Full Link Full
5
7
4
6
683EA
3-3