Config Diffserv Policy Bandwidth Kbps; Config Diffserv Policy Bandwidth Percent - NETGEAR GSM7324 Reference Manual

L3 managed switch 7000 series, software v1.0
Hide thumbs Also See for GSM7324:
Table of Contents

Advertisement

7000 Series L3 Managed Switch Reference Manual for Software v1.0
Format

config diffserv policy bandwidth kbps

This command identifies a minimum amount of bandwidth to be reserved for the specified class
instance within the named policy using an absolute rate notation. The
are the names of an existing DiffServ policy and class, respectively. The committed
<classname>
information rate is specified in kilobits-per-second (Kbps) and is an integer from 1 to 4294967295.
Note: The actual bandwidth allocation does not occur until the policy is attached to an interface in
a particular direction.
Note: The bandwidth kbps and percent commands are alternative ways to specify the same
bandwidth policy attribute.
Format
Restrictions
Policy Type
Incompatibilities

config diffserv policy bandwidth percent

This command identifies a minimum amount of bandwidth to be reserved for the specified class
instance within the named policy using a relative rate notation. The
are the names of an existing DiffServ policy and class, respectively. The committed
<classname>
information rate is specified as a percentage of total link capacity and is an integer from 1 to 100.
Note: The actual bandwidth allocation does not occur until the policy is attached to an interface in
a particular direction.
Note: The bandwidth kbps and percent commands are alternative ways to specify the same
bandwidth policy attribute.
9-16
config diffserv policy class remove <policyname>
<classname>
config diffserv policy bandwidth kbps <policyname>
<classname> <1-4294967295>
The sum of the committed information rate values for all band-
width and expedite commands defined within a policy must not
exceed the available link bandwidth of the interface to which that
policy is assigned. Violation of this requirement shall prevent
successful attachment of a policy to the interface, or shall cause
this command to fail if the policy is already in service on one or
more interfaces.
Out
Expedite (all forms)
May 30, 2003 Beta Draft
<policyname>
<policyname>
CLI Commands: Differentiated Services
and
and

Advertisement

Table of Contents
loading

Table of Contents