Match Destination-Address Mac; Match Dstip; Match Dstl4Port - NETGEAR GSM7224R - ProSafe Switch Cli Reference Manual

Command Line Interface Reference for the ProSafe 7200R Series Layer-2 Switches with Static

13.3.7 match destination-address mac

This command adds to the specified class definition a match condition based on the
destination MAC address of a packet. The <macaddr> parameter is any layer 2 MAC
address formatted as six, two-digit hexadecimal numbers separated by colons (e.g.,
00:11:22:dd:ee:ff). The <
need not be contiguous, and is formatted as six, two-digit hexadecimal numbers separated
by colons (e.g., ff:07:23:ff:fe:dc).
Default
Format
Mode

13.3.8 match dstip

This command adds to the specified class definition a match condition based on the
destination IP address of a packet. The
parameter specifies an IP address bit mask and must consist of a contiguous set
<ipmask>
of leading 1 bits.
Format
Mode

13.3.9 match dstl4port

This command adds to the specified class definition a match condition based on the
destination layer 4 port of a packet using a single keyword or numeric notation.
To specify the match condition as a single keyword, the value for
supported port name keywords. The currently supported
echo, ftp, ftpdata, http, smtp, snmp, telnet, tftp, www
translates into its equivalent port number. To specify the match condition using a numeric
notation, one layer 4 port number is required. The port number is an integer from 0 to
65535.
Format
Mode
Quality of Service (QoS) Commands
parameter is a layer 2 MAC address bit mask, which
macmask>
none
match destination-address mac
mask>
Class-Map Config
<ipaddr>
match dstip <ipaddr> <ipmask>
Class-Map Config
matchdstl4port {portkey | <0-65535>}
Class-Map Config
v1.0, November 2007
<macaddr> <mac-
parameter specifies an IP address. The
<portkey>
values are:
<portkey>
. Each of these
is one of the
domain,
13-13