Config Diffserv Class Match Dstip; Config Diffserv Class Match Dstl4Port Keyword; Config Diffserv Class Match Dstl4Port Number - NETGEAR ProSafe GSM7312 User Manual

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software

config diffserv class match dstip

This command adds to the specified class definition a match condition based on the destination IP
address of a packet. The
parameter specifies an IP address. The
that although similar to a standard subnet mask, this bit mask need not be contiguous. The optional
parameter has the effect of negating this match condition for the class (i.e., match all
[exclude]
destination IP addresses except for what is specified here).
Default
Format

config diffserv class match dstl4port keyword

This command adds to the specified class definition a match condition based on the destination
layer 4 port of a packet using a single keyword notation. The
existing DiffServ class. The value for
(listed below). The optional [exclude] parameter has the effect of negating this match condition for
the class (i.e., match all destination layer 4 port numbers except for the one specified here).
The currently supported
snmp, telnet, tftp, www
as both the start and end of a port range.
Note: The dstl4port keyword, number, and range commands are alternative ways to specify a
destination layer 4 port range as a match criterion.
Default
Format

config diffserv class match dstl4port number

This command adds to the specified class definition a match condition based on the destination
layer 4 port of a packet using a numeric notation. The
DiffServ class. One layer 4 port number is required. The port number is an integer from 0 to
65535. The optional
[exclude]
class (i.e., match all destination layer 4 port numbers except for the one specified here).
9-6
is the name of an existing DiffServ class. The
<classname>
<ipmask>
none
config diffserv class match dstip <classname> <ipaddr>
<ipmask> [exclude]
<portkey>
values are:
<portkey>
. Each of these translates into its equivalent port number, which is used
none
config diffserv class match dstl4port keyword
<classname> <portkey> [exclude]
parameter has the effect of negating this match condition for the
202-10009-01
parameter specifies an IP address bit mask; note
<classname>
is one of the supported port name keywords
domain, echo, ftp, ftpdata, http, smtp,
is the name of an existing
<classname>
<ipaddr>
is the name of an
Differentiated Services