Match Dstip; Match Dstl4Port - NETGEAR ProSafe GSM7324 Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-
• Any attempts to delete the
any
<class-map-name>
• The combined match criteria of
allowed combination based on the class type.
• Any subsequent changes to the
this validity, or the change attempt fails.
• The total number of class rules formed by the complete reference class chain
(including both predecessor and successor classes) must not exceed a platform-
specific maximum. In some cases, each removal of a refclass rule reduces the
maximum number of available rules in the class definition by one.
13.3.4.1 no match class-map
This command removes from the specified class definition the set of match conditions
defined for another class. The
whose match conditions are being referenced by the specified class definition.
Format
Mode

13.3.5 match dstip

This command adds to the specified class definition a match condition based on the
destination IP address of a packet. The
parameter specifies an IP address bit mask and must consist of a contiguous set
<ipmask>
of leading 1 bits.
Format
Mode

13.3.6 match dstl4port

This command adds to the specified class definition a match condition based on the
destination layer 4 port of a packet using a single keyword or numeric notation.
To specify the match condition as a single keyword, the value for
supported port name keywords. The currently supported
echo, ftp, ftpdata, http, smtp, snmp, telnet, tftp, www
translates into its equivalent port number. To specify the match condition using a numeric
notation, one layer 4 port number is required. The port number is an integer from 0 to
65535.
13-12
class while the class is still referenced by
<refclassname>
fails.
<class-map-name>
<refclassname>
is the name of an existing DiffServ class
<refclassname>
no match class-map <refclassname>
Class-Map Config
parameter specifies an IP address. The
<ipaddr>
match dstip <ipaddr> <ipmask>
Class-Map Config
v1.0, December 2005
and
<refclassname>
class match criteria must maintain
<portkey>
values are:
<portkey>
. Each of these
Quality of Service (QoS) Commands
must be an
is one of the
domain,