Match Any; Match Class-Map - NETGEAR ProSafe GSM7212 Cli Reference Manual

Command Line Interface Reference for the ProSafe 7200 Series Layer-2 Switches, Software Ver-

14.3.3 match any

This command adds to the specified class definition a match condition whereby all packets
are considered to belong to the class.
Format
Mode

14.3.4 match class-map

This command adds to the specified class definition the set of match conditions defined
for another class. The
match conditions are being referenced by the specified class definition.
Format
Mode
The following ruules apply to this command:
• The parameters
• Only one other class may be referenced by a class.
• Any attempts to delete the
any
<class-map-name>
• The combined match criteria of
allowed combination based on the class type.
• Any subsequent changes to the
this validity, or the change attempt fails.
• The total number of class rules formed by the complete reference class chain
(including both predecessor and successor classes) must not exceed a platform-
specific maximum. In some cases, each removal of a refclass rule reduces the
maximum number of available rules in the class definition by one.
14.3.4.1 no match class-map
This command removes from the specified class definition the set of match conditions
defined for another class. The
whose match conditions are being referenced by the specified class definition.
Format
Mode
Quality of Service (QoS) Commands
match any
Class-Map Config
is the name of an existing DiffServ class whose
<refclassname>
match class-map <refclassname>
Class-Map Config
and
<refclassname>
<refclassname>
fails.
<class-map-name>
<refclassname>
<refclassname>
no match class-map <refclassname>
Class-Map Config
v1.0, March 2006
can not be the same.
<class-map-name>
class while the class is still referenced by
and
<refclassname>
class match criteria must maintain
is the name of an existing DiffServ class
must be an
14-11