Set Garp Timer Leaveall; No Set Garp Timer Leaveall; Set Garp Timer Leaveall All; No Set Garp Timer Leaveall All - NETGEAR ProSafe GSM7212 User Manual

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software

set garp timer leaveall

This command sets how frequently Leave All PDUs are generated per port. A Leave All PDU
indicates that all registrations will be unregistered. Participants would need to rejoin in order to
maintain registration. The value applies per port and per GARP participation. The time may range
from 200 to 6000 (centiseconds).
Note: This command has an effect only when GVRP is enabled.
Default
Format
Mode

no set garp timer leaveall

This command sets how frequently Leave All PDUs are generated per port to 1000 centiseconds
(10 seconds).
Note: This command has an effect only when GVRP is enabled.
Format
Mode

set garp timer leaveall all

This command sets how frequently Leave All PDUs are generated for all ports. A Leave All PDU
indicates that all registrations will be unregistered. Participants would need to rejoin in order to
maintain registration. The value applies per port and per GARP participation. The time may range
from 200 to 6000 (centiseconds).
Note: This command has an effect only when GVRP is enabled.
Default 1000 centiseconds (10 seconds)
Format
Mode

no set garp timer leaveall all

This command sets how frequently Leave All PDUs are generated for all ports to 1000
centiseconds (10 seconds).
Note: This command has an effect only when GVRP is enabled.
8-46
1000 centiseconds (10 seconds)
set garp timer leaveall <200-6000>
Interface Config
no set garp timer leaveall
Interface Config
set garp timer leaveall all <200-6000>
Global Config
December 2004, 202-10010-02
Switching Commands