Set Garp Timer Leaveall; Show Garp - NETGEAR GSM7228PS Cli Manual

no set garp timer leave
This command sets the GVRP leave time on all ports or a single port to the default and only has an
effect when GVRP is enabled.
Format
no set garp timer leave
Mode • Interface Config
• Global Config

set garp timer leaveall

This command sets how frequently Leave All PDUs are generated. A Leave All PDU indicates
that all registrations will be unregistered. Participants would need to rejoin in order to maintain
registration. The value applies per port and per GARP participation. The time may range from 200
to 6000 (centiseconds). The value 1000 centiseconds is 10 seconds. You can use this command on
all ports (Global Config mode) or a single port (Interface Config mode), and it only has an effect
only when GVRP is enabled.
Default 1000
Format
set garp timer leaveall <200-6000>
Mode • Interface Config
• Global Config
no set garp timer leaveall
This command sets how frequently Leave All PDUs are generated the default and only has an
effect when GVRP is enabled.
Format
no set garp timer leaveall
Mode • Interface Config
• Global Config

show garp

This command displays GARP information.
Switching Commands
Managed Switch CLI Manual, Release 8.0.3
v1.0, July 2010
3-58