Procedure To Create The User Backup Image - Agilent Technologies ENA Series Service Manual

System Recovery
System Recovery

Procedure to create the user backup image

This section describes how to create the user backup image. The C drive contents saved in
this creation are recalled when the user recovery function is executed.
NOTE
This function is available when the volume label on the hard disk is AL200 or higher.
NOTE
You need the keyboard for this operation.
Step 1. Shut down the E5061A/E5062A.
Step 2. Connect the keyboard to the E5061A/E5062A.
Step 3. Insert the disk for the system recovery into the floppy disk drive of the E5061A/E5062A.
Step 4. Press the standby switch of the E5061A/E5062A to turn it on.
Step 5. When the screen as shown in the figure below appears, press and hold
keyboard until this screen disappears.
NOTE After several seconds, the next screen appears automatically even if you do not press any
key, so do not miss it.
If the above message does not appear, the instrument is at fault; contact your local Agilent
customer center listed at the end of this manual or distributor.
208
of the
Appendix B