Procedure To Create The User Backup Image - Agilent Technologies E4991A Service Manual

Procedure to create the user backup image

This section describes how to create the user backup image. The C drive contents saved in
this creation are recalled when the user recovery function is executed.
NOTE
This function is available when the volume label on the hard disk is IG201 or higher.
NOTE You need the keyboard for this operation.
Step 1. Shut down the E4991A.
Step 2. Connect the keyboard to the E4991A.
Step 3. Insert the disk for the system recovery into the floppy disk drive of the E4991A.
Step 4. Press the standby switch of the E4991A to turn it on.
Step 5. When the screen as shown in the figure below appears, press and hold
keyboard until this screen disappears.
NOTE
After several seconds, the next screen appears automatically even if you do not press any
key, so do not miss it.
If the above message does not appear, the instrument is at fault; contact your local Agilent
customer center listed at the end of this manual or distributor.
Appendix B
System Installation for A27 Mass Storage
System Recovery (for serial prefix MY433 and later)
of the
323