Turning Off The Updating Of Information Displayed On The Lcd Screen; Turning Off System Error Correction - Agilent Technologies ENA Series User Manual

Optimizing Measurements
Improving the Measurement Throughput

Turning Off the Updating of Information Displayed on the LCD Screen

Turning off the updating of information displayed on the LCD screen causes the processing
time required to update displays within the analyzer to be omitted, improving measurement
throughput. If it is not necessary to check displayed information during measurements,
turning off real-time updating is an effective means of improving throughput.
The updating of information displayed on the LCD screen can be switched using the
following procedure:
Turning Off the Updating of Information
Step 1. Press
Step 2. Press
When the LCD screen update is turned off,
Bar" on page 38.

Turning Off System Error Correction

The E5070A/E5071A executes "IF Range Correction" on page 457 and "Port
Characteristics Correction" on page 457 in the data processing flow shown in Figure E-2,
"Data Processing Flowchart," on page 456 by using the system calibration data set at the
factory. This system error correction process is not required if the user performs proper
calibration by using the
turns on error correction.
By turning off system error correction, you can reduce the data processing time during
measurement and thus improve measurement throughput.
NOTE
When you turn ON/OFF system error correction, all calibration data set by user calibration
is deleted.
Procedure
Step 1. Press
Step 2. Press
Step 3. Press
Figure 11-6 Dialog Box for System Error Correction Change
Step 4. Press
236
.
to switch the updating of displayed information on the LCD screen on/off.
Update
and subsequently appearing softkeys, which automatically
.
.
Service Menu
. Figure 11-6 appears.
System Correction
to turn ON/OFF system error correction.
OK
appears on "4. Instrument Status
Update Off
Chapter 11