Chapter 1 Introduction - Delta CT2000 Series User Manual

Receiving and Inspection
After receiving the AC motor drive, please check for the following:
1. Please inspect the unit after unpacking to assure it was not damaged during shipment. Make sure
that the part number printed on the package corresponds with the part number indicated on the
nameplate.
2. Make sure that the voltage for the wiring lie within the range as indicated on the nameplate. Please
install the AC motor drive according to this manual.
3. Before applying the power, please make sure that all the devices, including power, motor, control
board and digital keypad, are connected correctly.
4. When wiring the AC motor drive, please make sure that the wiring of input terminals "R/L1, S/L2,
T/L3" and output terminals"U/T1, V/T2, W/T3" are correct to prevent drive damage.
5. When power is applied, select the language and set parameter groups via the digital keypad
(KPC-CC01). When executes trial run, please begin with a low speed and then gradually increases
the speed untill the desired speed is reached.
Nameplate Information
Input Voltage/Current
Output Vol tag e Current
Encl osure Type (IPXX)
AC Drive Model
/
Frequency Range
Firmware Version
Certifications
Seria l Number
Chapter 1 IntroductionCT2000 Series

Chapter 1 Introduction

INP UT :
OUT PUT :
FR E QUE NCY RA N GE :
75 0T3E FJT 143 6 000 1
1-1
z 144
z 10 8
V A 115 A 10 0
144
V 105 A 84 A 100
D ALTA EL ECT R ON ICS. I NC .
M AD E IN xxxx xxxx