Delta CT2000 Series User Manual page 498

Table of Contents

Notes on operand usage:

n operand scope n ＝ 1 to 512

The content of n registers starting from the initial number of the device designated

device designated by

range used by that device, only points within the valid range will be sent.

3. When X10=On, the content of registers D0-D3 will be sent to the four registers

4. If the designated bit devices KnX, KnY, and KnM are sent,

have the same number of nibbles, which implies that n must be identical.

5. In order to prevent overlap between the transmission addresses of two operands,

which would cause confusion, make sure that the addresses designated by the

two operands have different sizes, as shown below:

: Initiate source device.

will be sent to the n registers starting from the initial number of the

, send in the order

, send in the order

Chapter 16 PLC Function CT2000 Series

16-bit command (7 STEP)

execution type

32-bit command

Flag signal: none

: Initiate destination device.

; if the number of points referred to by n exceeds the

execution type

: Send block

Show Quick Links

Table of Contents