Chapter 1 Introduction - Delta CP2000 Series User Manual

Receiving and Inspection
After receiving the AC motor drive, please check for the following:
1. Please inspect the unit after unpacking to assure it was not damaged during shipment.
2. Make sure that the part number printed on the package corresponds with the part number indicated
on the nameplate.
3. Make sure that the voltage for the wiring lie within the range as indicated on the nameplate.
4. Please install the AC motor drive according to this manual.
5. Before applying the power, please make sure that all the devices, including power, motor, control
board and digital keypad, are connected correctly.
6. When wiring the AC motor drive, please make sure that the wiring of input terminals "R/L1, S/L2,
T/L3" and output terminals"U/T1, V/T2, W/T3" are correct to prevent drive damage.
7. When power is applied, select the language and set the parameter groups via the digital keypad
(KPC-CC01).
8. After applying the power, please trial run with the low speed and then increase the speed gradually
to the desired speed.
Nameplate Information:
01 Introduction
1-1
Chapter01 Introduction to CP2000