Delta CT2000 Series User Manual page 299

Chapter 12 Description of Parameter SettingsCT2000 Series
101: CGdE CANopen software disconnect1
102: CHbE CANopen software disconnect2
103: Reserved
104: CbFE CANopen hardware disconnect
105: CIdE CANopen index setting error
106: CAdE CANopen slave station number
setting error
107: CFrE CANopen index setting exceed limit
108~110: Reserved
111: InrCOM Internal communication overtime
error
112: PM sensorless shaft lock error
113: Reserved
PTC (Positive Temperature Coefficient) Detection Selection

Settings
 Pr.06-29 setting defines how the will drive operate after PTC detection.
PTC Level

Settings
 It needs to set AVI/ACI/AUI analog input function Pr.03-00~03-02 to 6 (P.T.C. thermistor input
value).
 It is used to set the PTC level, and the corresponding value for 100% is max. analog input value.
Frequency Command for Malfunction

Settings
 When malfunction occurs, use can check the frequency command. If it happens again, it will
overwrite the previous record.
Output Frequency at Malfunction
Settings
 When malfunction occurs, use can check the current frequency command. If it happens
again, it will overwrite the previous record.
Fault Code
0: Warn and keep operating
1: Warn and ramp to stop
2: Warn and coast to stop
3: No warning
0.0~100.0%
0.00~599.00Hz
0.00~599.00Hz
Bit0 Bit1 Bit2
current Volt. OL
12.1-06-12
Bit3 Bit4 Bit5
SYS FBK EXI
●
Factory Setting: 0
Factory Setting: 50.0
Factory Setting: Read only
Factory Setting: Read only
Bit6
CE
●
●
●
●
●
●
●