Delta CT2000 Series User Manual page 196

NOTE
1. When Pr.10-01 is set to 1000 and Pr.10-02 is set to 1/2, the display range for PG feedback will be from
0 to 4000.
When Pr.10-01 is set to 1000 and Pr.10-02 is set to 3/4/5, the display range for PG feedback will be
from 0 to 1000.
Home position: If it has Z phase, Z phase will be regarded as home position. Otherwise, home position
will be the encoder start up position.
2. It can display negative values when setting analog input bias (Pr.03-03~03-10).
Example: assume that AVI input voltage is 0V, Pr.03-03 is 10.0% and Pr.03-07 is 4 (Serve bias as the
center).
3. Example: If REV, MI1 and MI6 are ON, the following table shows the status of the terminals.
0: OFF, 1: ON
Chapter 12 Description of Parameter SettingsCT2000 Series
21: Actual motor position (PG1 of PG card). When the motor direction
changes or the drive stops, the counter will start from 0 (display value
restarts counting from 0) (Max. 65535) (P.) The maximum value
showed as 32 bits.
22: Pulse input frequency (PG2 of PG card) (S.)
23: Pulse input position (PG2 of PG card) (max. 65535) (q.) The maximum
value showed as 32 bits.
24: Position command tracing error (E.)
25: Overload counting (0.00~100.00%) (o.) (Refer to Note 6)
26: GFF Ground Fault (Unit :%)(G.)
27:DC Bus voltage ripple (Unit: Vdc)(r.)
28: Display PLC register D1043 data (C) display in hexadecimal
29: Display PM motor pole section (EMC-PG01U application) (4.)
30 : Display output of user defined (U)
31 : H page x 00-05 Display user Gain(K)
32: Number of actual motor revolution during operation (PG card plug in
and Z phase signal input) (Z.)
33: Motor actual position during operation (when PG card is connected)(q)
34: Operation speed of fan(%) (F.)
35: Control Mode display: 0= Speed control mode (SPD), 1= torque control
mode (TQR) (t.)
36: Present operating carrier frequency of drive (Hz) (J.)
37: Reserved
38: Display drive status (6.) (Refer to Note 7)
39: Display estimated output torque, positive and negative, using Nt-m as
unit (t 0.0: positive; -0.0 negative torque (C.)
40: Torque command (L.) (Unit: %)
41: Display the kWH (J) (Unit: kWH)
42: PID reference (h.) (Unit: %)
43: PID offset (o.) (Unit: %)
44: PID output Fcmd (Hz) (b.) (Unit: Hz)
45: Hardware ID
12.1-00-3