Delta CT2000 Series User Manual page 575

Chapter 16 PLC Function CT2000 Series
Step 6: Connect hardware wiring
When performing wiring, note the head and tail terminal resistance; connection methods are
as follows:
VFD- CT
Termina l
resistor
Step 7: Initiate control
After a program has been written and downloaded, switch the PLC mode to Run. Merely
turn power to master and slave stations off and then on again.
Refer to CANMasterTest 1 vs. 2 driver.dvp
( Maste r) V FD -CT ( Sl ave)
V FD-CT ( Sl ave )
16-134
VFD- CT (S la ve)
Termina l
resistor