Delta CT2000 Series User Manual page 286

 Pr.05-26~05-29 records the amount of power consumed by motors. The accumulation begins
when the drive is activated and record is saved when the drive stops or turns OFF. The amount of
consumed watts will continue to accumulate when the drive activate again. To clear the
accumulation, set Pr.00-02 to 5 then the accumulation record will return to 0.
Accumulative Motor Operation Time (Min)
Settings
Accumulative Motor Operation Time (day)
Settings
 Pr. 05-31 and Pr.05-32 are used to record the motor operation time. To clear the operation time, set
Pr.05-31 and Pr.05-32 to 00. Operation time shorter than 60 seconds will not be recorded.
Induction Motor (IM) and Permanent Magnet Motor Selection
Settings
Full-load current of Permanent Magnet Motor
Settings
Rated Power of Permanent Magnet Motor

Settings
Rated speed of Permanent Magnet Motor

Settings
Pole number of Permanent Magnet Motor
Settings
Inertia of Permanent Magnet Motor
Settings
 This parameter setting is defined in kg-cm
the chart below. (Delta's motor inertia chart is for reference purpose only.)
Chapter 12 Description of Parameter SettingsCT2000 Series
00~1439
00~65535
0: Induction Motor
1: Permanent Magnet Motor
2: IPM Permanent Magnet Motor
Depends on the power of motor
0.00~655.35 kW
0~65535 rpm
0~65535
2
0.0~6553.5 kg.cm (0.0001kg.m
12.1-05-8
2
)
2
. If this measure is not familiar to you, please refer to
Factory Setting: 0
Factory Setting: 0
Factory Setting: 0
Factory Setting:
Depends on the power
of motor
Factory Setting: 0.00
Factory Setting: 2000
Factory Setting: 10
Factory Setting:
Depends on the power
of motor