Delta CT2000 Series User Manual page 232

Settings Functions
Mechanical gear ratio
48
switch
49 Drive enable
50 Slave dEb execution
Selection for PLC mode
51
bit0
Selection for PLC mode
52
bit1
Enable CANopen quick
53
stop
54 Reserved
55 Brake Released Signal
56 LOCAL/REMOTE Selection
57~70 Reserved
UP/DOWN Key Mode

Settings
Constant speed. The Accel. /Decel. Speed of the UP/DOWN Key

Settings
 These settings are used when multi-function input terminals are set to 19/20. Refer to Pr.02-09 and
02-10 for the frequency up/down command.
 Pr.02-09 set to 0: it will increase/decrease frequency command (F) by the external terminal
UP/DOWN key as shown in the following diagram. In this mode, it also can be controlled by
UP/DOWN key on the digital keypad.
F requenc y
External ter minal
UP k ey
Chapter 12 Description of Parameter SettingsCT2000 Series
When this contact is ON, the mechanical gear ratio switch will be
the second group A2/B2 (refer to Pr.10-08 and Pr.10-09).
When drive=enable, RUN command is valid.
When drive= disable, RUN command is invalid.
When drive is in operation, motor coast to stop.
Input the message setting in this parameter when dEb occurs to
Master. This will ensure dEb also occurs to Slave, then Master and
Slave will stop simultaneously.
PLC status
Disable PLC function (PLC 0)
Trigger PLC to operation (PLC 1)
Trigger PLC to stop (PLC 2)
No function
When this function is enabled under CANopen control, it will
change to quick stop. Refer to Chapter 15 for more details.
Use Pr.00-29 to select for LOCAL/REMOTE mode(refer to
Pr.00-29)
When Pr.00-29 is not set to 0, on the digital keypad KPC-CC01 it
will display LOC/REM status. (It will display on the KPC-CC01 if the
firmware version is above version 1.021).
0: Up/down by the accel/decel time
1: Up/down constant speed (Pr.02-10)
0.001~1.000Hz/ms
F requenc y c ommand
ON
12.1-02-9
Descriptions
Bit 0
REM 0
LOC 1
UP
T ime
DOWN
OFF
Bit 1 Bit 0
0 0
0 1
1 0
1 1
Factory Setting: 0
Factory Setting: 0.001
Ml1~15
Ml1~15
DCM
VFD-C