Delta CT2000 Series User Manual page 153

Chapter 10 Digital KeypadCT2000 Series
Warning Code
LCM Display *
Warning
Modbus function code error
CE01
Comm Command Er
Warning
Modbus data address error
CE02
Comm Address Er
Warning
Modbus data value error
CE03
Comm Data Error
Warning
Modbus slave drive error
CE04
Comm Slave Error
Warning
Modbus transmission time-Out
CE10
KpdCom m Time O ut
Warning
Object not supported by TP
TPNO
Editor
TP No Object
Description
Motor drive doesn't accept the communication
command sent from keypad.
1. Verify if the keypad is properly connected to the
2. Press RESET on the keypad to clear errors.
If none of the solution above works, contact your local
authorized dealer.
Motor rive doesn't accept keypad's communication
address.
1. Verify if the keypad is properly connected to the
2. Press RESET on the keypad to clear errors.
If none of the solution above works, contact your local
authorized dealer.
Motor drive doesn't accept the communication data
sent from keypad.
1. Verify if the keypad is properly connected to the
2. Press RESET on the keypad to clear errors.
If none of the solution above works, contact your local
authorized dealer.
Motor drive cannot process the communication
command sent from keypad.
1. Verify if the keypad is properly connected to the
2. Press RESET on the keypad to clear errors.
3. Shut down the system, wait for ten minutes, and
If none of the solution above works, contact your local
authorized dealer.
Motor drive doesn't respond to the communication
command sent from keypad.
1. Verify if the keypad is properly connected to the
2. Press RESET on the keypad to clear errors.
3. Shut down the system, wait for ten minutes, and
If none of the solution above works, contact your local
authorized dealer.
Keypad's TP Editor uses unsupported object.
1. Verify how the TP editor should use that object.
2. Reedit the TP editor and then download it.
If none of the solution above works, contact your local
authorized dealer.
10-32
Corrective Actions
motor drive on the communication contact by a
communication cable such as RJ-45.
motor drive on the communication contact by a
communication cable such as RJ-45.
motor drive on the communication contact by a
communication cable such as RJ-45.
motor drive on the communication contact by a
communication cable such as RJ-45.
then power on again the system.
motor drive on the communication contact by a
communication cable such as RJ-45.
then power on again the system.
Delete unsupported object and unsupported
setting.