Delta CT2000 Series User Manual page 130

5. Copy PLC
4 duplicates are provided
The steps are shown in the example below.
Example: Saved in the motor drive.
1 Go to Copy PLC
2 Select a parameter group to copy then press
ENTER
1 Select 1: Save in the motor drive.
2. Press ENTER key to go to "Save in the motor
drive" screen.
Begin to copy PLC until it is done.
Once copying PLC is done, keypad will automatically
be back to this screen.
NOTE
verify if the PLC program is built-in to KPC-CC01
keypad.
keypad while "Option 1: Save in the motor drive" is
selected, an "ERR8 Warning: Type not matching" will
be display on the screen.
the PLC program will have a CPLt warning.
Example: Saved in the keypad.
1.
automatically be back to this screen.
2. Select the parameter group which needs to be
copied and press ENTER key.
drive" screen.
set, enter the password to save the file onto digital
display.
file name.
String & Symbol Table:
！＂＃＄％＆＇（）＊＋，－．／０１２３４５６７８９：；＜＝＞？＠Ａ
ＢＣＤＥＦＧＨＩＪＫＬＭＮＯＰＱＲＳＴＵＶＷＸＹＺ［＼］＾＿｀ａｂ
ｃｄｆｇｈｉｊｋｌｍｎｏｐｑｒｓｔｕｖｗｘｙｚ｛｜｝～
10-9
Chapter 10 Digital KeypadCT2000 Series
If "Option 1: Save in the motor drive" is selected,
If PLC program is not available in the
Unplug and plug back the keypad while copying
Once copying PLC is done, keypad will
Press ENTER key to go to "Save in the motor
If WPLSoft editor is installed and password is
Use Up/Down key to select a symbol.
Use Left/Right key to move the cursor to select a