Delta CT2000 Series User Manual page 333

Chapter 12 Description of Parameter SettingsCT2000 Series
Content Address
Bit9
Bit10
Bit11
Bit12
Bit13~15
2102H Frequency command (F)
2103H Output frequency (H)
2104H Output current (AXX.X.X)
2105H DC-BUS Voltage (UXXX.X)
2106H Output voltage (EXXX.X)
2107H Current step number of Multi-Step Speed Operation
2108H Reserved
2109H Counter value
201AH Power Factor Angle (XXX.X)
201BH Output Torque (%)
201CH Actual motor speed (rpm)
201DH Number of PG feed back pulses
201EH Number of PG2 pulse commands
201FH Power output (X.XXX)
2116H Multi-function display (Pr.00-04)
211BH Max. opeartion frequency (Pr.01-00) or Max. user defined value
(Pr.00-26)
2200H Display output current (A)
2201H Display counter value of TRG terminal (c)
2202H Display actual output frequency (H)
2203H Display DC-BUS voltage (u)
2204H Display output voltage of U, V, W (E)
2205H Display output power angle of U, V, W (n)
2206H Display actual motor speed kW of U, V, W (P)
2207H Display motor speed in rpm estimated by the drive or encoder
feedback (r00: positive speed, -00: negative speed)
2208H Display positive/negative output torque in %, estimated by the
drive (t0.0: positive torque, -0.0: negative torque)
2209H Display PG feedback (as NOTE 1)
220AH Display PID feedback value after enabling PID function in % (b)
220BH Display signal of AVI analog input terminal, 0-10V corresponds
to 0-100% (1.) (as NOTE 2)
220CH Display signal of ACI analog input terminal, 4-V20mA/0-10V
corresponds to 0-100% (2.) (as NOTE 2)
220DH Display signal of AUI analog input terminal, -10V~10V
corresponds to -100~100% (3.) (as NOTE 2)
220EH Display the IGBT temperature of drive power module in
220FH Display the temperature of capacitance in
2210H The status of digital input (ON/OFF), refer to Pr.02-12 (as
NOTE 3)
2211H The status of digital output (ON/OFF), refer to Pr.02-18 (as
NOTE 4)
2212H Display the multi-step speed that is executing (S)
2213H The corresponding CPU pin status of digital input (d.) (as NOTE
3)
2214H The corresponding CPU pin status of digital output (O.) (as
NOTE 4)
2215H Number of actual motor revolution (PG1 of PG card) (P.) it will
start from 9 when the actual operation direction is changed or
keypad display at stop is 0. Max. is 65535 (P.)
2216H Pulse input frequency (PG2 of PG card)(S.)
12.1-09-9
Function
1: Master frequency controlled by analog signal
1: Operation command controlled by
communication interface
1: Parameter locked
1: Enable to copy parameters from keypad
Reserved
o
C (c.)
o
C (i.)