Delta CT2000 Series User Manual page 343

Chapter 12 Description of Parameter SettingsCT2000 Series
Output Setting for Frequency Division (denominator)

Settings
 This parameter is used to set the denominator for frequency division (for PG card EMC-PG01L or
EMC-PG01O). For example, when it is set to 2 with feedback 1024ppr, PG output will be
1024/2=512ppr.
Electrical Gear at Load Side A1

Electrical Gear at Motor Side B1

 Electrical Gear at Load Side A2
Electrical Gear at Motor Side B2

Settings
 Parameters 10-04 to 10-07 can be used with the multi-function input terminal (set to 48) to switch
to Pr.10-04~10-05 or Pr.10-06~10-07 as shown as follows
2: Phase B leads in a forward run command and phase A leads in a reverse
run command
FWD
A
B
3: Phase A is a pulse input and phase B is a direction input. (L =reverse
direction, H=forward direction)
FWD
A
B
4: Phase A is a pulse input and phase B is a direction input. (L=forward
direction, H=reverse direction)
FWD
A
B
5: Single-phase input
A
1~255
1~65535
load
encoder is us ed
at load side
12.1-10-2
REV
REV
REV
PG
car d
Gear
Gear
B1 or B2
A1 or A2
gear ratio
ON = A2: B2
MI=48
OFF=A 1:B 1
Factory Setting: 1
Factory Setting: 100
Driv er
Motor