Delta CT2000 Series User Manual page 296

84: OPHL W phase output phase loss
85: PG-02U ABZ hardware disconnection
86: PG-02U UVW hardware disconnection
87~88: Reserved
89: Initial rotor position detection error
90: Inner PLC function is forced to stop
91~100: Reserved
101: CGdE CANopen software disconnect1
102: CHbE CANopen software disconnect2
103: Reserved
104: CbFE CANopen hardware disconnect
105: CIdE CANopen index setting error
106: CAdE CANopen slave station number setting error
107: CFrE CANopen index setting exceed limit
108~110: Reserved
111: InrCOM Internal communication overtime error
112: PM sensorless shaft lock error
113: Reserved
When th
 e fault occurs and force stopping, it will record in this parameter.
 At stop with low voltage Lv (LvS warn, no record). During operation with mid-low voltage Lv (LvA,
Lvd, Lvn error, will record).
 Setting 62: when dEb function is enabled, the drive will execute dEb and record to the Pr.06-17 to
Pr.06-22 simultaneously.
 Fault Output Option 1
 Fault Output Option 2
 Fault Output Option 3
 Fault Output Option 4
Settings
 These parameters can be used with multi-function output (set to 35-38) for the specific
requirement. When the fault occurs, the corresponding terminals will be activated (It needs
to convert binary value to decimal value to fill in Pr.06-23 to Pr.06-26).
Fault Code
0: No fault
1: Over-current during acceleration (ocA)
2: Over-current during deceleration (ocd)
3: Over-current during constant speed(ocn)
4: Ground fault (GFF)
5: IGBT short-circuit (occ)
6: Over-current at stop (ocS)
Chapter 12 Description of Parameter SettingsCT2000 Series
0 to 65535 sec (refer to bit table for fault code)
12.1-06-9
Bit0 Bit1 Bit2
current Volt. OL
●
●
●
●
●
●
Factory Setting: 0
Bit3 Bit4 Bit5
SYS FBK EXI
Bit6
CE