Chapter 4 Configuring Node-Wide Default Parameters; Node Defaults; Node Defaults Configuration Screen 1 - Cabletron Systems FRM User Manual

Node Defaults

Configuring Node-Wide Default Parameters
Node Defaults are a set of parameters that identify an FRM for purposes of remote
control, software updates, file transfers, and/or alarm reporting to or from a remote
FRM, SmartSwitch 1800, FRX4000, or FRX6000. The Node Defaults file also con-
tains information that defines a connection to a NetView manager device.
Press at the Node Configuration Menu to display a screen similar to Figure 4-1.
[C]
This is the first of three Node Defaults screens—pressing
the display among the three screens.
The first two screens contain parameters that apply to all users. The third screen con-
tains parameters used in sessions between a NetView host and the NetView service
point function in the FRM. If the NetView function will not be used, the third screen
does not have to be configured.
Node Defaults C onfiguration (Screen 1 of 3)
A Nod e Name
B Remote C ontrol ID
C Remote C ontrol Pw d
D File Trans fer I D
E File Trans fer Pwd
F Collecting FR M ID
G Collecting FR M Pw d
H Primary A larm Outp ut ID
I Primary A larm Outp ut Pw d
J Secondary Alarm Ou tput ID
K Secondary Alarm Ou tput Pwd
Op tion :
Figure 4-1 Node Defaults Configuration Screen 1
[PgDn]
N ode N ame=node_xyz
D atabase S ystem Memory
n ode_xyz n ode_xyz
[A],[A],[C]
from Main Menu
Chapter 4
or will change
[PgUp]