Table of Contents
Advertisement
Subscriber Parameters
Subscriber Name
Routing Algorithm
Configuring X.25
In this case, other system factors will determine whether line 1,0 or line 1,2 will be
selected. If we assume 1,0 is selected, the new values of
line 1,2 the next call:
Line
U
0,0
4
1,0
4
1,1
failed
1,2
2
If the database is changed and lines are added or deleted from the routing path config-
uration, or if lines become operational or not operational, the next Call Request will
trigger new
values based on the lines available at the moment. As operational lines
U
fill up their LCNs they are excluded from getting new calls. If all operational lines
have all LCNs in use, new calls will be cleared.
Parameter
Subscriber Name
Routing Algorithm
Systematic Redirection
Redirect on Busy
Redirect on Out of Order
Connection Priority
1st,2nd,etc. Path Configur ed
RLP
Port
Redirection Address 0,1,etc.
The software does not verify that a specified port exists. Make sure the port is configured
1
in the database.
identifies the subscriber to the console operator.
allows creation of a "hunt group" of ports (see example on
of routing per a pre-selected algorithm:
= Round Robin – selects ports specified cyclicly in numerical order according
0
to the list of Redirection Addresses. If the selected port is unreachable or con-
gested, the Call Request will be sent to the next port. (If the port becomes
available again, it will be included in its assigned position.)
= Alternate Route on Line Failure – selects the first port that is not in a failed
1
state. If the selected port does not make a connection, the call will be cleared, even
if other ports are available.
Table 8-3 Subscriber Parameters
Valid Values
0–31 characters
0–3
Y/N
Y/N
Y/N
0–9
Y/N
0–3
Physical port:
Logical port:
valid address
will be as follows, giving
U
Default Value
none
0
N
N
N
0
N
0
1
0–7
1
8-63
0
none
page
8-24), for the purpose
8-25
Advertisement
Table of Contents
