Step 3. Setting The Trigger; Step 4. Setting The Display To Trace; Figure 3-2 Trace Display In Dual Channel Power Meter - Keysight N1911A User Manual

3 Using P-Series Power Sensor
When you have completed the procedure you can return to this menu later to add
more accuracy to the measurement.

Step 3. Setting the trigger

To use the measurement gates the power meter must be triggered.
A trigger can be taken from a rising or falling measured power level or controlled
externally using the Ext Trig input.
Press
The trigger status is displayed below the
the
When you have completed the procedure you may return to the Trigger menu
later to add more accuracy to the remaining trigger parameters, to help you
achieve a stable and reliable trigger.

Step 4. Setting the display to trace

Using trace display provides a visual representation of the signal of interest.
Press
Figure 3-2
154
. The Trigger menu is displayed.
softkey and select
Acqn
,
Disp Type
Trace display in dual channel power meter
Acqn
to configure continuous triggering.
Cont Trig
, to display the Trace window.
Trace
Keysight N1911A/1912A User's Guide
label in the Trigger menu. Press