Setting The Display And The Starting Condition - Keysight CX3300 Series User Manual

Using the CX3300

Setting the Display and the Starting Condition

Setting the Display and the Starting Condition

The following keys are available for setting up the CX3300 display and starting
condition quickly. They are located in the Horizontal control on the front panel.
•
•
•
•
To enable/disable the touch screen, press the
right corner on the front panel. The indicator is lit green when the touch panel
operation is effective.
For setting up the CX3300 quickly, you can reuse the saved acquisition setup. To
reuse the setup, click the Load icon on the sidebar. For saving the setup, see
"Saving and Printing Data" on page
50
To automatically set up the CX3300 for the present input signal(s), press the
key. Auto scaling is applied to the waveform supported by the graph
Auto Scale
scale.
To enable/disable the high resolution mode of acquisition, press the
key. Enabling the mode automatically reduces sampling rate and memory
depth to get clean waveforms. The
effective.
To clear waveform on the graph, press the
The CX3300 clears acquired waveform data from the graph in preparation for
another acquisition. If the CX3300 is in Run mode and is receiving triggers, it
will update the graph as it collects new waveform data.
Clearing the waveform also clears the analysis graph and data.
To apply the default setup, press the
key is lit when the mode is
High Reso
Clear Display
key.
Default Setup
Touch Panel
80.
Keysight CX3300 User's Guide, Edition 4
High Reso
key.
key located in the lower