Handler I/O Port; Ethernet Port; External Monitor Output Terminal (Video); Gpib Connector - Agilent Technologies ENA Series User Manual

Overview of Functions
Rear Panel: Names and Functions of Parts

1. Handler I/O Port

The terminal to which an automatic machine (handler) used on a production line is
connected. For more on using the handler I/O port, see the Programmer's Guide.
Connector type: 36-pin Ribbon (Centronics) connector

2. Ethernet Port

A terminal for connecting the E5070B/E5071B to a LAN (Local Area Network).
Connecting this instrument to a LAN enables you to access the hard disk drive of this
instrument from an external PC or to control this instrument by using SICL-LAN or telnet.
Connector type: 8-pin RJ-45 connector
Base standard: 10Base-T/100Base-TX Ethernet (automatic data rate selection)

3. External Monitor Output Terminal (Video)

A terminal to which an external color monitor (display device) can be connected. By
connecting a color monitor to this terminal, the same information shown on the LCD
screen of the main body can be displayed on an external color monitor.
Connector type: 15-pin VGA connector, female

4. GPIB Connector

General Purpose Interface Bus (GPIB). The connection of an external controller and other
devices through this connector allows you to configure an automatic measurement system.
For more on the automatic measurement system using GPIB, see the Programmer's Guide.

5. External Trigger Input Connector (Ext Trig)

A connector to which external trigger signals are input. This connector detects the
downward transition from the HIGH state in TTL signals as the trigger signal. To use this
connector to generate a trigger, you must set the trigger source to the "external" side (key
operation: - - ).
Trigger Source External
Connector type: BNC connector, female

6. Fan

The cooling fan for controlling the temperature inside the E5070B/E5071B. This fan
exhausts heated air from inside the analyzer to the outside.

7. Line Switch (Always ON)

Always keep this switch on (|).
CAUTION
Do not use this switch to turn off ( ) the mains. Doing so may cause the analyzer to
fail. For more information, see the description of the "1. Standby Switch" on page 31.
Chapter 2 55