Table of Contents
Advertisement
System Speci cations Summary
he speci cations and characteristics in this section describe the system performance of the
analyzer. hese speci cations are valid only after the analyzer has been turned on and allowed
to warm up for at least one hour.
his section is a summary of the full System Speci cations. For a complete listing of the
analyzer's speci cations, see \Speci cations and Characteristics" in the
Speci cations
(indicated by boldface type) describe the analyzer's warranted performance
over the temperature range of 25 C
Supplemental characteristics
intended to provide information useful in applying the analyzer.
Measurement Port Speci cations
he following speci cations describe the residual system uncertainties. hese speci cations
apply after a user enhanced response calibration has been performed and within an
environmental temperature range of 25 C
calibration temperature.
Directivity
HP 8711C/12C/13C/14C/30A
Source match
HP 8711C/12C/13C/14C/30A
P 8711C/12C/30A
300 kHz to 1000 MHz
1000 kHz to 1300 MHz
P 8730A Only
10 MHz to 100 MHz
P 8713C/14C
300 kHz to 1300 MHz
1300 MHz to 3000 MHz
Source Speci cations
Range
HP 8711C/12C/30A
HP 8713C/14C
Accuracy
1-2
Performance T ests
6
5 C, unless otherwise stated.
(indicated by italics) are typical, but nonwarranted parameters,
6
5 C, with less than 1 C deviation from the
Directivity and Source Match
40 dB
30 dB
Load Match
20 dB
18 dB
30 dB
20 dB
18 dB
Frequency
300 kHz to 1300 MHz
300 kHz to 3000 MHz
6
5 ppm at 25 C
< 1 Hz at 10% change in line voltage
ser's Guide
.
6
5 C
Advertisement
Table of Contents
