Setting The Trigger Source For Calibration - Agilent Technologies ENA Series User Manual

Rf network analyzers

Hide thumbs Also See for ENA Series:

Table of Contents

Setting the trigger source for calibration

You can set the trigger source for calibration before executing calibration.

You can select it from "Internal" or "System." Setting it to "System" allows you to use the

same trigger source setting for calibration and measurement.

You can set the trigger source for calibration (which is usually set to "Internal") to

"System," which allows you to generate triggers at any timing from a PC for external

control or from the front panel for calibration in the same way as for measurement.

The setting of the point trigger and averaging trigger is also applied to the trigger for

calibration. When the trigger source for calibration is set to "System" and the trigger

source for measurement is set to "External" or "Manual" with the point trigger function set

to ON, a trigger is required for each measurement point during calibration.When the

averaging trigger function is set to ON, the sweep is performed the number of times

specified by the averaging factor for a single trigger during calibration.

For the following types of calibration, the setting of the trigger source does not take effect.

Those calibration operations are controlled by the internal trigger.

Follow these steps to set the trigger source for calibration.

Step 1. Press

Step 2. Press

Step 3. Select the trigger source you want to use.

Calibration using ECal

Power calibration

Receiver calibration

Mixer converter calibration

Cal Trig Source

Selects "Internal."

Selects "System."

E5070b E5071b